JBD Smart BMS 7~21S 8S 16S 20S 200A 300A Communicant PCB with Relay Support UART, Bluetooth or RS485 Function for Lithium Battery LiFePo4 Li-ion
SMART BMS MODEL: JBD-AP21S002
This is Jiabaida/JBD offical store on Shopify.
We have smart and hardware bms for lifepo4 and li-ion lithium battery and support to be customized. Please contact us if need more support and cooperation.
JBD-AP21S002 is a software protection board scheme specially designed for 7~21 strings of lithium battery packs. The product adopts architecture of front-end acquisition chip + MCU, and some parameters can be flexibly adjusted through the host computer according to customer needs.
|7~21 strings of Lithium Iron Battery
|Charge and discharge are both at the same port
|3.6V*Number of strings
|Consumption of sleep
|Delay 65000s under no current \ communication \ protection
|200±2mm * 114.5±0.5mm * 51±1mm
1. Overcharge protection and recovery
2. Over-discharge protection and recovery
3. Charging overcurrent protection and recovery
4. Discharge overcurrent protection and recovery
5. Temperature Protection and Recovery
6. Balance function
7. Capacity calculation
8. Sleep function
Xiangxiang APP for ANDROID & IOS:
RS485/UART SW for WINDOWS TOOL:
Quick UK delivery very impressed.
BMS 300A version a little overkill for my needs until I add more batteries.
Initial setup was ok but you must follow the diagram instruction precisely where it shows for instant an 8s cell 6-19 balance cable s must all connect together. I have seen videos where people have claim you cut the excess cables do not the BMS it will not after.
It is an active balancer which means it’s switching is quite audible when it shuts on and off charge or discharge ports respectively. I am having an issue with this switching on and off sound when connected to a 3kw inverter on a lower current than 2Amp. Have tried changing APP parameters to recognised a lower input mA voltage of 50mA but keeps going back to 200mA standard setting which is unhelpful. Not sure if it’s an app issue or BMS range won’t go to 50mA.
Other than this seems to balance much better than other BMS’s. The Xiaoxiang app worked at first then I installed the Elephant App and the App stopped working.
Will update you as soon as these things get fixed.
This is the first JBD BMS that I have installed. I was very impressed with the quality and assembly of the unit. It would be very helpful to have a detailed wiring schematic included with the unit. We are building a 12s 36 volt 304 ah battery and cannot find a wiring schematic for that voltage. We have it paired and all inputs entered however it says it has 14 cells and we can not change it to get a cell voltage read out. Still working on it.
All right, like again…
Good material, works perfectly.