Recognize Your BMS---Basic Function of Battery Management System

 BMS WEBSITE: jiabaidabms.com

       Nowadays, the lithium battery become more and more popular in the world, especially in developing countries and regions. But for the long serving time of battery packs, the bms have a large market gradually to fit the requirements.

       Do you know the BMS, which also called protection boards, have many protective functions for the lithium battery. Normally the cell we can see is the LIFEPO4 (3.2V) & NMC (3.7V). There are two main type of bms, divided into normal bms (hardware pcb) and smart bms (software bms). 

       Toady I'll introduce the common functions between normal and smart bms, for they both have the basic function as the protection board. Following six basic function of bms you should be known:

        Overcharge protection: When the battery is under the charging state, the voltage keeps going up. When the protection board detects that the voltage of any cell is higher than the overcharge protection value, the protection board will start timing immediately. When the time reaches the overcharge protection delay, the protection board will turn off the charging MOS tube, at that time, it cannot be charged.

        Overcharge protection recovery: After the overvoltage protection appears on the protection board, the battery voltage will going down under the static or discharge state of the battery. When the protection board detects that each voltage is lower than the recovery voltage of the overcharge protection, the protection board will output a signal and turn on the charging MOS tube to charge.
       Over-discharge protection: When the battery is under the discharge state, the voltage keeps going down. When the protection board detects that the voltage of any cell is lower than the overcharge protection value, the protection board will start timing immediately. When the time reaches the over discharge protection delay, the output signal of the protection board will turn off the discharge MOS tube, the load lock circuit will work, but, it cannot discharge at this time.
       Over discharge protection recovery: After the over discharge protection appears on the protection board, the battery voltage will going up under the static or discharge state of the battery. When the protection board detects that each voltage is higher than the recovery voltage of the over discharge protection. At this time, disconnect the load or charge, the protection board will output a signal and turn on the charging MOS tube to charge.
       Overcurrent protection: When the battery is under the static or discharge state, the current suddenly increases. When the protection board detects that the current reaches the overcurrent protection value, the protection board will start timing at that time. When the current duration in the circuit reaches the overcurrent protection delay time, the output signal of the protection board will turn off the discharge MOS tube, and the load lock circuit will work. At this time, the discharge cannot be conducted.
        Overcurrent protection recovery: After the discharge overcurrent protection appears on the protection board, the discharge MOS tube is turned off, and the current in the loop becomes 0. At this time, the load is disconnected or charged, the output signal of the protection board will turn on the discharge MOS tube to discharge.

       When you pick bms for battery, I think these functions are really important, and the parameters are also needed to be confirmed in accordance with your requirements.

BMS : jiabaidabms.com(free shipping and huge discount in limited time)

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.